Regulatory Compliance Information

BrightSign Regulatory Compliance Information

FCC Rules, Part 15.

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Responsible Party:

BrightSign, LLC.

500 S. Winchester Blvd., Suite 100, San Jose, CA 95128

USA Telephone: 1-408-852-9263

ICES-003 Class B Notice:

(Avis NMB-003, Classe B)

This Class B digital apparatus complies with Canadian ICES-003.

European Community Compliance Statement

This product is in conformity with the protection requirements of EC Council Directive 2004/89/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility. BrightSign, LLC., cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product. This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to CISPR 32/European Standard EN 55032 and EN 55035. The limits for Class B equipment were derived for typical environments to provide reasonable protection against interference with licensed communication devices. Properly shielded and grounded cables and connectors must be used in order to reduce the potential for causing interference to radio and TV communications and to other electrical or electronic equipment.

Declaration of Conformity

This product is in conformity with the requirements of Directive Electromagnetic Compatibility Directive (2014/30/EU) & Electromagnetic Compatibility Regulations 2016. Means of proving conformity with the essential requirements (standards/specifications used):

Wireless Operation Channel for Different Domains

Country Code selection feature to be disabled for products marketed to the US/CANADA.

• N. America 2.412-2.462 GHz Ch01 through CH11
• Japan 2.412-2.484 GHz Ch01 through Ch14
• Europe ETSI 2.412-2.472 GHz Ch01 through Ch13

France Restricted Wireless Frequency Bands

Some areas of France have a restricted frequency band. The worst case maximum authorized power indoors are:

• 10mW for the entire 2.4 GHz band (2400 MHz–2483.5 MHz)
• 100mW for frequencies between 2446.5 MHz and 2483.5 MHz

Channels 10 through 13 inclusive operate in the band 2446.6 MHz to 2483.5 MHz. There are few possibilities for outdoor use: On private property or on the private property of public persons, use is subject to a preliminary authorization procedure by the Ministry of Defense, with maximum authorized power of 100mW in the 2446.5–2483.5 MHz band. Use outdoors on public property is not permitted in the departments listed below, for the entire 2.4 GHz band:

• Maximum authorized power indoors is 100mW
• Maximum authorized power outdoors is 10mW

Departments in which the use of the 2400–2483.5 MHz band is permitted with an EIRP of less than 100mW indoors and less than 10mW outdoors:

• 01 Ain Orientales 02 Aisne 03 Allier
• 05 Hautes Alpes 08 Ardennes 09 Ariège
• 11 Aude 12 Aveyron 16 Charente
• 24 Dordogne 25 Doubs 26 Drôme
• 32 Gers 36 Indre 37 Indre et Loire
• 41 Loir et Cher 45 Loiret 50 Manche
• 55 Meuse 58 Nièvre 59 Nord
• 60 Oise 61 Orne 63 Puy du Dôme
• 64 Pyrénées Atlantique 66 Pyrénées 67 Bas Rhin
• 68 Haut Rhin 70 Haute Saône 71 Saône et Loire
• 75 Paris 82 Tarn et Garonne
• 84 Vaucluse 88 Vosges 89 Yonne
• 90 Territoire de Belfort 94 Val de Marne

This requirement is likely to change over time, allowing you to use your wireless LAN card in more areas within France. Please check with ART for the latest information (www.art-telecom.fr). BrightSign Wireless (WiFi) devices transmit less than 100mW, but more than 10mW.

UL Safety Notices

Required for UL 1459 covering telecommunications (telephone) equipment intended to be electrically connected to a telecommunication network that has an operating voltage to ground that does not exceed 200V peak, 300V peak-to-peak, and 105V rms, and installed or used in accordance with the National Electrical Code (NFPA 70).When using the BrightSign Player, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

• DO NOT use near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement or near a swimming pool.
• DO NOT use during an electrical storm. There may be a remote risk of electric shock from lightning.
• DO NOT use in the vicinity of a gas leak.